Fastener Processing
Feb 27, 2025
Leave a message
Fasteners include bolts, studs, screws, nuts, washers, and pins. Locking or biting often occurs on fasteners made of stainless steel, aluminum alloy, and titanium alloy materials. These metal alloys themselves have anti-corrosion properties, and when the surface is damaged, a thin oxide layer will be formed on the metal surface to prevent further corrosion. When stainless steel fasteners are locked, the pressure and heat generated between the teeth will damage this oxide layer, causing blockage or shear between the metal threads, leading to adhesion. When this phenomenon continues to occur, the stainless steel fasteners will be completely locked and can no longer be removed or locked again. Usually, this series of actions of blocking, shearing, sticking, and locking occur in just a few seconds, so correctly understanding and using such fasteners can prevent this phenomenon.
1. Choose the right product Before use, confirm whether the mechanical properties of the product can meet the usage requirements, such as the tensile strength of screws and the guaranteed load of nuts. The length of the screw should be selected appropriately, based on the 1-2 tooth pitch exposed after tightening the nut. b. Before use, check whether the threads are rough and whether there are iron filings or dirt between the threads, which can often cause locking. c. Before use, lubrication treatment can be applied to the fasteners. It is recommended to use butter, molybdenum disulfide, mica, graphite or talcum powder for lubrication. Generally, wax immersion treatment is used for lubrication and anti locking.
2. Pay attention to the usage method when using a The speed and force of the screw in should be appropriate, not too fast or too strong. Try to use torque wrenches or socket wrenches as much as possible, and avoid using adjustable wrenches or electric wrenches. Excessive speed can cause a rapid rise in temperature and lead to locking. b. The direction of force application must be perpendicular to the axis of the screw when screwing in the nut. c. The use of washers can effectively prevent the problem of locking too tightly.
